4.18. Хонингование cylinders

1.  Before хонингованием  cylinders establish covers of radical bearings and tighten fixing bolts till the demanded moment of an inhaling.

17.2а If you do not have wide experience in хонинговании cylinders, use a wire honing-head

17.2б the Honing-head should leave the uniform drawing which lines are crossed under a corner 60 °

2. For хонинга cylinders it is possible to use a special brush for хонинга  or a honing-head. Establish a head in the cylinder, include a drill and move a head in the cylinder upwards-downwards with such speed that on walls cylinders the strips crossed under a corner 60 (17.2а, 17.2б) were formed. At хонинговании use a greasing considerable quantity. After drill deenergizing, do not take out a honing-head at once from the cylinder, and wait, while it will stop.

3. After end хонинга chamfer the top edge of the cylinder by means of a file.

4. Process all cylinders and carefully wash out the block of cylinders warm, soap water.

5. Dry up the block and grease with its anticorrosive oil.