Mitsubishi Colt (with 1983 for 1993 of release)
1. The maintenance instruction of cars Mitsubishi Colt / Lancer / Mirage / Galant / Eterna / Saporro / Sigma / Magna / Cordia / Tredia / Precis with 1983 for 1993 of release
2. Adjustment and current maintenance service
3. The engine
4. An engine partition
4.1. Technical characteristics
4.2. The general description
4.3. Engine major repairs - the general remarks
4.4. Diagnostics of the engine by means of the vacuum gauge, check of a compression and dismantle of the power unit (security measure)
4.5. Installation of the piston of cylinder N 1
4.6. Engine removal - the general description
4.7. The engine - removal and installation
4.8. Engine major repairs - alternative methods
4.9. An engine partition - a dismantling order
4.10. A head of the block of cylinders - dismantling
4.11. A head of the block of cylinders - clearing and survey
4.12. Valves - repair and installation
4.13. A head of the block of cylinders - assemblage
4.14. Pistons and rods - removal
4.15. A cranked shaft - removal
4.16. The block of cylinders - clearing
4.17. The block of cylinders - survey
4.18. Хонингование cylinders
4.19. Pistons and rods - survey
4.20. A cranked shaft - survey
4.21. Loose leaves radical and шатунных bearings - survey
4.22. An engine partition - an assembly order
4.23. Piston rings - installation
4.24. A cranked shaft - installation and check of a lubricant backlash of radical bearings
4.25. Installation of a back epiploon of a cranked shaft
4.26. Pistons and rods - installation and check of a lubricant backlash of the bearing
4.27. The first start of the engine after a partition
5. Systems of cooling, heating and an air conditioning
6. The power supply system and release of the fulfilled gases
7. An engine electric equipment
8. Systems of decrease in toxicity of exhausts
9. A mechanical transmission
10. An automatic transmission
11. Coupling and semiaxes
12. Brake system
13. A suspension bracket and a steering
14. A body
15. A body electric equipment
 





4a8e3442






4-16-blok-cilindrov-ochistka.html

4.16. The block of cylinders - clearing


15.1 For removal заглушек use a stripper


1. Drill apertures in заглушках and get them by means of a stripper (15.1).
2. Remove traces of an old lining and hermetic from a surface of the block of cylinders.
3. Remove covers of radical bearings and loose leaves.
4. Remove all заглушки the block of cylinders.
5. If the engine very dirty address to experts for its clearing.
6. After block clearing, clean oil channels and wash out their warm water. Dry up the block of cylinders and grease with anticorrosive oil.

15.7 Clean carving apertures in the block of cylinders


7. Clean carving apertures in the block of cylinders with the help мечика, then blow their compressed Air (15.7).
8. Establish covers of radical bearings into place, and slightly tighten fixing bolts.

15.9 For installation new заглушек use the big head and the extension piece


9. Grease заглушки with hermetic Permatex N2 and establish them on the block of cylinders (15.9).
10. Grease with hermetic (such as Permatex N2 or hermetic for pipes Teflon) new заглушки oil channels and twirl them in apertures in the block of cylinders.
11. If you do not continue engine assemblage, cover with its plastic package


4.15. A cranked shaft - removal

4.17. The block of cylinders - survey