Mitsubishi Colt (with 1983 for 1993 of release)
1. The maintenance instruction of cars Mitsubishi Colt / Lancer / Mirage / Galant / Eterna / Saporro / Sigma / Magna / Cordia / Tredia / Precis with 1983 for 1993 of release
2. Adjustment and current maintenance service
3. The engine
4. An engine partition
4.1. Technical characteristics
4.2. The general description
4.3. Engine major repairs - the general remarks
4.4. Diagnostics of the engine by means of the vacuum gauge, check of a compression and dismantle of the power unit (security measure)
4.5. Installation of the piston of cylinder N 1
4.6. Engine removal - the general description
4.7. The engine - removal and installation
4.8. Engine major repairs - alternative methods
4.9. An engine partition - a dismantling order
4.10. A head of the block of cylinders - dismantling
4.11. A head of the block of cylinders - clearing and survey
4.12. Valves - repair and installation
4.13. A head of the block of cylinders - assemblage
4.14. Pistons and rods - removal
4.15. A cranked shaft - removal
4.16. The block of cylinders - clearing
4.17. The block of cylinders - survey
4.18. Хонингование cylinders
4.19. Pistons and rods - survey
4.20. A cranked shaft - survey
4.21. Loose leaves radical and шатунных bearings - survey
4.22. An engine partition - an assembly order
4.23. Piston rings - installation
4.24. A cranked shaft - installation and check of a lubricant backlash of radical bearings
4.25. Installation of a back epiploon of a cranked shaft
4.26. Pistons and rods - installation and check of a lubricant backlash of the bearing
4.27. The first start of the engine after a partition
5. Systems of cooling, heating and an air conditioning
6. The power supply system and release of the fulfilled gases
7. An engine electric equipment
8. Systems of decrease in toxicity of exhausts
9. A mechanical transmission
10. An automatic transmission
11. Coupling and semiaxes
12. Brake system
13. A suspension bracket and a steering
14. A body
15. A body electric equipment
 





4a8e3442






4-17-blok-cilindrov-osmotr.html

4.17. The block of cylinders - survey

1. Before block survey clear it.
2. Examine the block on presence of cracks and corrosion. Check up a carving in carving apertures.
3. Examine cylinders on presence of scratches and jags.

16.4а Measure diameter of cylinders in the top part (hardly below a ledge), on the middle and in the bottom part in parallel an axis of a cranked shaft


16.4б Measure diameter of cylinders by means of the telescopic gauge


16.4в Measure length of the gauge by means of a micrometer


4. Measure diameter of cylinders in the top part (hardly below a ledge), on the middle and in the bottom part in parallel an axis of a cranked shaft (16.4а, 16.4б and 16.4в).
5. Then measure diameter of each cylinder in the same places across an axis of a cranked shaft.
6. Check up a backlash between pistons and walls of cylinders by means of a set щупов.
7. If walls of cylinders are scratched, cylinders have got the conic or oval form, address to experts for расточки and хонингования cylinders.
8. If cylinders are perfectly in order also backlashes between walls of cylinders and pistons correspond to demanded values everything, that it is necessary othoningo-vat cylinders.


4.16. The block of cylinders - clearing

4.18. Хонингование cylinders