Mitsubishi Colt (with 1983 for 1993 of release)
1. The maintenance instruction of cars Mitsubishi Colt / Lancer / Mirage / Galant / Eterna / Saporro / Sigma / Magna / Cordia / Tredia / Precis with 1983 for 1993 of release
2. Adjustment and current maintenance service
3. The engine
4. An engine partition
5. Systems of cooling, heating and an air conditioning
6. The power supply system and release of the fulfilled gases
7. An engine electric equipment
8. Systems of decrease in toxicity of exhausts
9. A mechanical transmission
10. An automatic transmission
11. Coupling and semiaxes
12. Brake system
13. A suspension bracket and a steering
14. A body
15. A body electric equipment
15.1. The general description
15.2. Detection of malfunctions in electric equipment system - the general description
15.3. Safety locks - the general description
15.4. Burnt through crosspieces - the general description
15.5. Automatic switches - the general description
15.6. The relay - the general description
15.7. The ignition lock - removal and installation
15.8. The combined switch - removal and installation
15.9. Headlights of head light - removal and installation
15.10. Headlights of head light - adjustment
15.11. Replacement of bulbs
15.12. A speedometer rope - removal and installation
15.13. An instrument guard - removal and installation
15.14. Cruise-control system - the description and check
15.15. Electric стеклоподъемники - the description and check
15.16. The central lock - the description and check
15.17. Electric equipment schemes - the general description
 





4a8e3442






15-3-predokhraniteli-obshhee-opisanie.html

15.3. Safety locks - the general description

Electric chains of the car are protected by a set of safety locks, automatic switches and burnt through crosspieces. Blocks of safety locks are located under the panel of devices, on left or on right (on some models) a wall, and also, in an impellent compartment near the accumulator.
Each of safety locks protects the chain and on the safety lock panel there is a designation of a chain protected by this safety lock.
In the block of safety locks three types of tiny safety locks are used. These compact safety locks with contacts in the form of plates can be removed and established fingers. If any of electric equipment elements ceases to work, always, first of all, check up a safety lock. The fused safety lock is easy for defining, having looked at a connecting delay through the transparent plastic case. Examine the safety lock case on presence of damages. If it is necessary to check up, whether has fused a safety lock of type And its contact plates act from the safety lock case.
At replacement of the fused safety lock always use a new safety lock of the same capacity, as old. Safety locks of various capacity are physically interchangeable, however it is necessary to use safety locks only demanded capacity. Replacement of a safety lock by a safety lock большей or smaller capacity is not recommended. Various protection is required to various electric chains. Capacity of a safety lock is specified on самомпредохранителе. If the new safety lock fuses at once, it is necessary to find the reason of it before to establish a new safety lock. The most probable reason перегорания a safety lock is short circuit in a chain, caused by the torn or worn out wire.


3.1а the Block of safety locks is located on a left-hand side of the panel of devices - some safety locks are established under a folding cover



3.1б On models of later years of release one more block of safety locks in an impellent compartment near the accumulator is established



3.1в the Fused safety lock can be defined visually
A.Horoshy
. Fused
Check of integrity of a chain




15.2. Detection of malfunctions in electric equipment system - the general description

15.4. Burnt through crosspieces - the general description