|
12-6-tormoznojj-disk-osmotr-snyatie-i-ustanovka.html
12.6. A brake disk - survey, removal and installation1. Lift the car and remove a wheel.
|
|
5.2 Suspend a support on a wire piece
|
2. Remove a support of a brake, an overlay and an arm of a support ( 5.2). Survey
3. Examine a disk surface on presence of scratches or damages. If scratches are deeper 0,38 mm - it is necessary to replace a disk.
|
|
5.4а Check up disk palpation with the help циферблатного the gauge
|
|
|
5.4б Circular movements process a surface of a disk a skin
|
4. Check up disk palpation with the help циферблатного the gauge ( 5.4а and 5.4б).
|
|
5.5а is minimum admissible thickness of a brake disk is specified on an internal part of a disk
|
5. Is minimum admissible thickness of a disk is specified on a disk. The thickness of a disk can be checked up by means of a micrometer ( 5.5а and 5.5б).
|
|
5.5б Check up a thickness of a disk by means of a micrometer in several points
|
Removal and installation
6. On some models the brake disk can be removed from a nave after removal of a support and a support arm.
7. Remove a rotary pin and a nave from the car.
8. For removal of a nave and a brake disk from a rotary pin address to experts.
9. Establish a rotary pin and a nave.
10. Establish a support, an arm of a support and brake overlays. Tighten bolts or fingers of a support till the demanded moment of an inhaling.
11. Establish a wheel and lower the car on the earth.
| 