1-43-16-zamena-kolesa.html
1.43.16. Wheel replacementTo tighten to the full a manual brake. At an inclined plane проезжей parts in addition to block a wheel being opposite by means of a wedge or a stone.
By means of a key for installation of wheels and wire скобы to remove decorative caps, to suspend wire скобу in a dual aperture on the brink of a cap, to insert a key through скобу and to hook a cap as the lever.
By means of a key to turn on nuts/bolts approximately on one turn.
To establish a jack against the stop in the corresponding basis (drawing). If it is necessary, carefully before it to clean a place for a jack emphasis! Whenever possible, to establish a jack in vertical position.
At the soft basis to enclose under a jack a strong support of the big area.
To unscrew nuts/bolts and to remove a wheel.
In cars with aluminium disks to replace covers of a nave of a wheel.
To establish a spare wheel and slightly to tighten all nuts/bolts.
To provide strong planting of a spare wheel, on surfaces прилегания to a nave of a wheel or a brake drum and to nuts/bolts there should not be neither a dirt, nor a rust.
To lower the car, and with the help крестовины to tighten to the full nuts/bolts.
Instructions
After wheel replacement it is necessary as soon as possible with the help динамометрического a key to check up pressure of inflating of the established spare wheel and the moment of an inhaling of bolts/nuts.
Attention! The jack put from factory is intended only for a raising of the car of such type as yours In no event by means of this jack heavy vehicles or other cargoes should not rise It is forbidden to work under the car lifted by means of a jack
If subsequently it is required to equip the car with other tyres or disks which will differ from established on factory without fail it is necessary to consider corresponding instructions described earlier
|