|
6-14-korpus-drosselya-modeli-s-dvukhtochechnym-vpryskom-topliva-tbi.html
6.14. The throttle case (models with point-to-point injection of fuel TBI) - removal, a partition and installationRemoval
1. Let out pressure from the power supply system. Disconnect a wire of the minus plug of the accumulator. Merge cooling liquid. Disconnect all necessary hoses, wires and branch pipes.
2. Mark position of the gauge of position throttle заслонки and remove it.
|
|
13.3 Elements of the case of a throttle
1. A cover демпфера
2. A sealing ring
3. A spring
4. Демпфер
5. Sealing rings (2)
6. A regulator of pressure of fuel
7. The amalgamator
8. A hose
9. A sealing ring
10. The throttle case
11. The gauge of position throttle заслонки
12. Connection
13. An arm
14. A returnable spring
15. The lever throttle заслонки 16 Ring
17. The disconnecting lever
18. The lever of inclusion of a hill-climbing gear
19. The adjusting screw
20. A spring
21. Sealing rings (2)
22. Injectors
23. Plugs (2)
24. Sealing rings (2)
25. Fastening
26. A vacuum diaphragm
27. A spring
28. A returnable spring
|
3. Turn off fixing screws and remove fastenings of injectors ( 13.3). 4. Get injectors from the case. Remove linings of injectors and other elements.
Partition
5. Clear all elements, except a vacuum diaphragm and the gauge of position throttle заслонки in solvent. Check up, that vacuum and fuel channels have not been littered.
Installation
|
|
13.6а Check up correctness of installation of a sealing ring of an injector
1. The top party
2. A sealing ring
|
|
|
13.6б At installation of the gauge of position throttle заслонки check up, that the ledge "In" has got to a groove "And"
|
|
|
13.6в Check up resistance between plugs 1 and 2 or 2 and 3 sockets of connection of the gauge of position throttle заслонки at opening заслонки
|
| 