Mitsubishi Colt (with 1983 for 1993 of release)
1. The maintenance instruction of cars Mitsubishi Colt / Lancer / Mirage / Galant / Eterna / Saporro / Sigma / Magna / Cordia / Tredia / Precis with 1983 for 1993 of release
2. Adjustment and current maintenance service
3. The engine
4. An engine partition
5. Systems of cooling, heating and an air conditioning
5.1. Technical characteristics
5.2. The general information
5.3. Antifreeze - the general information
5.4. The thermostat - check and replacement
5.5. A radiator - removal and installation
5.6. The fan of cooling of the engine - check and replacement of elements
5.7. The gauge of temperature of a cooling liquid - check and replacement
5.8. A broad tank of system of cooling - removal and installation
5.9. The water pump - check
5.10. The water pump - replacement and installation.
5.11. The engine of system of heating and an air conditioning - removal and installation.
5.12. A heater radiator - replacement
5.13. Air and heating central air - replacement, installation of wires.
5.14. Air central air - check and routine maintenance
5.15. A reception tube of the conditioner - removal and installation
5.16. The compressor of a central air of air - removal and installation
5.17. The condenser of a central air of air - removal and installation
6. The power supply system and release of the fulfilled gases
7. An engine electric equipment
8. Systems of decrease in toxicity of exhausts
9. A mechanical transmission
10. An automatic transmission
11. Coupling and semiaxes
12. Brake system
13. A suspension bracket and a steering
14. A body
15. A body electric equipment
 





4a8e3442






5-16-kompressor-sistemy-kondicionirovaniya-vozdukha-snyatie-i-ustanovka.html

5.16. The compressor of a central air of air - removal and installation

Attention! Air central air is under the big pressure. The system should be discharged on a car repair shop.
Removal
1. Disconnect a wire of the minus plug of the accumulator.
2. Put the car on a lay brake.
3. Lift a forward part of the car and establish on axial support.
4. Unscrew the pallet and remove приводной a belt.
5. Disconnect a connection socket муфты from the compressor.

15.6 Tubes and compressor bolts (are specified by arrows) air central airs.


6. Disconnect tubes of a central air from the compressor and immediately isolate open sites to avoid dirt and moisture hit in system (15.6).
7. Turn off fixing bolts and remove the compressor from a fixing arm.
Attention! Carrying out the given procedure it is necessary to support liquid level in the compressor. If the compressor has jammed, or in the pipeline metal parts the system should be washed out the expert are found out, and it is necessary to replace a reception tube of the conditioner.
Installation
8. Scroll the central part муфты six times to remove the remained oil on a head.
9. Installation is spent upside-down removals.
10.  If you establish the new compressor, read Section about calculation of quantity of oil.
11. Check up pressure and tightness of a central air of air.



5.15. A reception tube of the conditioner - removal and installation

5.17. The condenser of a central air of air - removal and installation