Mitsubishi Colt (with 1983 for 1993 of release)
1. The maintenance instruction of cars Mitsubishi Colt / Lancer / Mirage / Galant / Eterna / Saporro / Sigma / Magna / Cordia / Tredia / Precis with 1983 for 1993 of release
2. Adjustment and current maintenance service
3. The engine
3.1. Technical characteristics
3.2. The general information and engine identification
3.3. The repair operations, which carrying out it is possible without removal of the engine from the car
3.4. A cover of valves - removal and installation
3.5. Коромысла - removal, check and installation
3.6. Springs of valves, fastenings and overlays - replacement
3.7. Hydraulic regulators of valves - removal, check and installation
3.8. Газораспределительный a belt and asterisks - removal, check and installation
3.9. A forward epiploon of a cranked shaft - replacement
3.10. Camshafts - removal, check and installation
3.11. An inlet collector - removal and installation
3.12. A final collector - removal and installation
3.13. A head of cylinders - removal and installation
3.14. The oil pallet - removal and installation
3.15. The oil pump - removal, check and installation
3.16. A flywheel - removal and installation
3.17. A back epiploon of a cranked shaft - replacement
3.18. Engine support - check and replacement
4. An engine partition
5. Systems of cooling, heating and an air conditioning
6. The power supply system and release of the fulfilled gases
7. An engine electric equipment
8. Systems of decrease in toxicity of exhausts
9. A mechanical transmission
10. An automatic transmission
11. Coupling and semiaxes
12. Brake system
13. A suspension bracket and a steering
14. A body
15. A body electric equipment
 





4a8e3442






3-18-opory-dvigatelya-proverka-i-zamena.html

3.18. Engine support - check and replacement

1. It is necessary to replace the worn out or broken fastenings of the engine immediately.
Check
2. At carrying out of check the engine is necessary for raising a little to remove pressure from fastenings.
3. Lift the car and fix it on props. Establish a jack under the oil pallet and lift the engine.
4. Check up rubber shock-absorbers of fastenings
5. Lower the engine and tighten clips of fastenings.
6. For reduction of deterioration it is possible to cover shock-absorbers with special structure.
Replacement
7. Disconnect a wire from the minus plug of the accumulator, lift the car and fix it on props.

17.8а the Left fastening is located near to a cover газораспределительного a belt and attached to the engine by two bolts and nuts (are specified by arrows) (2,0)


17.8б the Left fastening of the engine (1,5)


17.8в transmission Fastening


17.8г Back fastening


17.8д Forward fastening


8. Remove clips of fastenings and remove fastenings (17.8а, 17.8б, 17.8в, 17.8г, 17.8д).
9. Establish new shock-absorbers in fastenings.
10. Establish fastenings on places.


3.17. A back epiploon of a cranked shaft - replacement

4. An engine partition