3-14-maslyanyjj-poddon-snyatie-i-ustanovka.html
3.14. The oil pallet - removal and installationRemoval
1. Disconnect a wire of the minus plug of the accumulator.
2. Lift the car and establish it on support.
3. Remove грязезащитный the pallet from under the engine, get щуп and merge engine oil.
4. Unscrew a forward exhaust pipe from a final collector.
|
13.5а Arrows specify bolts of the oil pallet
|
|
13.5б Knock with a wooden hammer on the pallet
|
) Also lower the oil pallet. If the pallet has stuck, knock on it with a wooden hammer ( 13.5б).
6. Clean the oil pallet and joined surfaces. Clean off traces of an old lining.
Installation
|
13.7 If the pallet has no lining put glue-hermetic
1. Hermetic
2. Hermetic should lie in a flute
3. Hermetic should is put from the interior of a bolt
|
7. If the oil pallet has no lining, put 4 mm a glue-hermetic layer on a joined surface of the pallet ( 13.7). If the lining is used, paste its thin layer of hermetic.
8. Establish the pallet into place and tighten bolts a hand.
Then tighten bolts in diagonal sequence till the demanded moments of an inhaling.
9. Establish the remained details.
10. Fill in in the engine engine oil.
|