2.5. Check of level of oil and liquids

4.1а Щуп for check of level of oil it is located near за­жима on some models

4.1б the Arrangement щупа for check of level of oil on мо­делях Galant

4.1в oil Level should be between marks MIN and the MOVE on щупе - if is not present, доба­вьте oil to lift its level to a mark the MOVE (for a raising of level of oil from отме­тки MIIM to a mark the MOVE требу­ется about 1 litre of oil)

4.1г Turn a cover зали­вной mouths on a floor of a turn and remove they be do not forget очи­стить area round a cover before its removal

1. For check of level of oil serves щуп, located sideways on a forward part of the engine. Check of level of oil is necessary for spending before a trip on the car or in 15 minutes after engine deenergizing (4.1а, 4.1б, 4.1в and 4.1г).

Attention! Watch that antifreeze did not get on a skin or the painted surface of a body. Смойте the spilt antifreeze a water considerable quantity. Do not leave the new container with antifreeze opened and do not leave antifreeze poured - the sweet smell of antifreeze can involve children or pets. Inhalation even an antifreeze small amount can lead to a fatal outcome.

4.2 Check up that level of a cooling liquid in a tank was between top and ни­жней marks - if it below the bottom mark, add охла­ждающую a liquid to demanded level.

On all models the system of cooling of the closed type is used. The white plastic tank of a cooling  liquid  is located  in  an impellent compartment and connected by a hose to a jellied mouth of a radiator (4.2). Regularly check liquid level in a tank. When the engine cold, liquid level should be hardly above mark LOW in a tank. When the engine прогрет, level of a cooling liquid should rise to mark FULL. If is not present, add 50 %-s' mix of water and antifreeze on a basis этиленгликоля.

4.3а On some models the tank of a washing liquid is located near a tank of a cooling liquid - do not mix these two tanks

4.3б On other models the tank of a washing liquid is located separately from a tank охла­ждающей liquids - remove a cap and add washing liquid

3. The plastic tank of a washing liquid is located in an impellent compartment. In a cold season use  antifreeze  for  a washing  liquid (4.3а and 4.3б).

4.4 Remove caps of sections of the accumulator and check up electrolit level - if it is lowered, add the distilled water

4. On all models described in this management, the accumulator which is not demanding additional service and the additive of electrolit (4.4) is established.

4.5а Level of a brake liquid should be between marks MIN and the MOVE-turn off a cap for liquid addition

4.5б On some models liquid level should be between marks the MOVE and And (and should not fall below a mark)

5. The main brake cylinder is located on the forward  party  of a servoamplifier   in  an impellent compartment. The main cylinder of a drive of deenergizing of coupling is located near to the main brake cylinder. Liquid level should be between marks MIN and the MOVE on a tank (4.5а and 4.5б).