10-9-avtomaticheskaya-korobka-peredach-snyatie-i-ustanovka.html
10.9. An automatic transmission - removal and installationRemoval
1 Disconnect wires and remove the accumulator and a shelf Remove the air filter
2. Lift the car and establish it on support.
3. Merge a liquid of an automatic transmission.
4. Remove a hydrotransformer casing.
|
8.5 Mark position of installation of the hydrotransformer on a leading disk by means of a white paint
|
5. Mark position of installation of the hydrotransformer on a leading disk by means of a white paint ( 8.5).
6. Turn off three bolts of fastening of the hydrotransformer to a leading disk.
7. Remove a starter.
8. Disconnect semiaxes from a transmission.
9. Disconnect all vacuum hoses, wires and ropes from a transmission.
10. Establish support under the engine and a transmission.
11. Remove the suspension bracket elements, transmissions stirring to removal.
12. Turn off bolts, крепящие a transmission to the engine.
13. Turn off nuts and bolts and disconnect transmission fastening.
14. Slightly lower a transmission, disconnect and stop up tubes of system of cooling.
15. Take away a transmission from the engine and remove it from the car.
Installation
16. Before installation check up, that the hydrotransformer nave has been reliably established in the pump.
17. Lift a transmission into place and connect hoses of system of cooling.
18. Turn the hydrotransformer so that to combine apertures for fixing bolts and made before a mark.
19. Establish a transmission on the engine.
20. Establish bolts of fastening of a transmission to the engine and reliably tighten them. Establish transmission fastening.
21. Insert bolts of fastening of the hydrotransformer to a leading disk and twirl them till the demanded moment of an inhaling.
22. Establish all earlier removed elements and tighten bolts and nuts till the demanded moment of an inhaling.
23. Fill in a liquid of an automatic transmission and conduct road tests.
|